JS concrete mixer matters need to pay attention when debugging

Mixing machine, a shaft with blades rotating in the cylinder or tank, mixing the various raw materials, making it a mixture or a suitable consistency of machines. There are compulsory mixing machine, single horizontal shaft mixing machine, twin-shaft mixing machine. When mixing machine debugging, you should pay attention the following points.

1, to check the lubrication of the gear box and various lubricants adequacy is good.
2. Check the power supply voltage: Rated voltage is 380 volts, the error is ± 10%.
3. Check the motor and electrical components wiring is solid, reliable power distribution box housing must be grounded. Power distribution box neutral must find N terminal block, all lines should be properly resettled, while working to prevent accidents caused by crushing hit.
4, start stirring motor, two axle direction of rotation should be consistent with signs indicating directions, such as the wrong direction, the power wiring should be changed
5, boot volume field motor lifting hopper, hopper raised to unloading position, should automatically stop, Doumen automatically opens.

6, start unloading mechanism, the discharge door opening and closing should be accurate place. Start the pump to draw water, water supply systems should operate normally.
7, according to the desired ratio of concrete to determine the amount of water, and adjusted to the appropriate water supply time relay time. Start stirring motor running.
8, close the discharge gate, adding the desired mix within the hopper, lifting hopper.

9, stirring 25-35 seconds, start unloading discharge door.
10, in the above commissioning process, if found to be normal, you should immediately stop inspection, troubleshooting, and then test again, you know normal. The new machine running the liner after use, and elsewhere to deal with bolts and nuts all day, checking the tightening. Parts of transmission lubrication grease lubrication.